Frequency switch movement radar detector ceiling light lighting st700

Frequency switch movement radar detector ceiling light lighting ST700
This product is a new switching system for energy saving, it is composed of an electromagnetic wave microwave sensor high frequency (5.8 GHz) and a logic circuit. It includes the automation functions, convenience, security easily achieve energy savings. The sensing field of the detector is wide. It works by detecting human movement. When one enters the detection field, it will light the light and automatically detects the day and night. Its installation is very convenient and its use is very wide. Detection is possible through doors, windows, glass or thin walls.
SPECIFICATIONS:
Food: 220V/AC-240V/AC Detection range: 360 °
Power Frequency: 50Hz Detection distance: 1-8m (radius) adjustable
Ambient Light: 3-2000LUX (adjustable) HF system: 5.8GHz CW radar, ISM band
Time delay: min:. 10sec ± 3s Transmitting power: <10 mW
Max. 12min ± 1min Installation height: 1.5 m ~ 3.5 m
Rated power: 1200 W Power Consumption (Bulb): 0.9 W
300W (energy saving lamp) Speed ??Motion Detection: 0.6 ~ 1.5 m / s
FUNCTION:
- Can identify day and night: It can work in the day and at night when it is set to "sun" position (max). It can operate at lower 3LUX ambient light when it is set to the "moon" position (min).
- Adjustable SENS: The sensibillitée can be adjusted depending on the location and distance detection, with only a low sensitivity detection distance (1 m radius), high sensitivity up to 8 m (radius), should such for a large room.
- Timed and added continually: When it receives the induction signals after the first induction, it will calculate the time once again on the basis of the first rest timer.
- The delay time is adjustable. It can be adjusted according to the consumer's desire. The minimum time is 10sec ± 3sec. The maximum is ± 1min 12min.
NOTE: The high frequency of the sensor output is <10mW it is only a hundredth of the transmission power of a mobile phone or the output of a microwave oven.

Intallation (see diagram)
- Turn off the power.
- Remove the top cover according to the diagram.
- Unscrew the middle, set down in the selected position with broad screws.
- Connect the power supply and load circuit of the sensor according to the diagram sketch son connection. Then screw the lid in the middle.
- The buttoning on the sensor top cover, with the cover by turning it clockwise. Then you can turn on and do the tests